Move in a Circle

Sometimes we don’t want to move in a straight line or perform a point turn (as the turn left / turn right commands do). In this case we can use the “set motor” block:

set-motor

We can choose a motor (M1 – left, M2 – right) and a power level (negative powers move in reverse). In this way, we can perform swing turns (where one motor is turned off and the other is on):

set-both-motors

Or we can move in circles:

go-in-a-circle

Challenge:

  1. Write a program so your robot moves in a figure-of-eight.
  2. Write a program so your robot spells your initials.

Construct Your Dreams!