Ranger add on packs

mBot Ranger add-on pack

mBot Ranger add-on pack Laser Sword

mBlock case programs

We provide mBot Ranger Laser Sword add-on pack with more than one mBlock case program. Introductions and download links of each case program are as below.

Click here to download.

  • Varying-color Charge Sword

Introduction:

When the finger gets close to “sensor 2” at the line follower sensor, the Laser Sword enters into “Charge State” and LED luminance increases. When LED luminance reaches to the maximum extent, the laser sword enters “Supercharged State”, the on-board LEDs flash and an “alarm” sounds.

  • Rainbow Sword

Introduction: When the Laser Sword is enabled, the on-board LEDs and LEDs at the RGB LED strip will light up one by one, producing a “rainbow” effect. When “sensor 1” and “sensor 2” at the line follower sensor are touched at the same time, the on-board LEDs and LEDs at the RGB LED strip will go out one by one until all LEDs go out. When “sensor 1” or “sensor 2” is not touched, the on-board LEDs and LEDs at the RGB LED strip will light up one by one, thus producing a “rainbow” effect again.

  • Sound Control Lamp

Introduction: When a sound of certain loudness is detected by the on-board sound sensor in the dark, the RGB LED strip will light up. The strip will go out after a while.

Instruction: The Laser Sword may be hung on the wall to act as a Sound Control Lamp.

  • Optical Control Lamp

Introduction: When the ambient luminance is below a certain value, the Laser Sword will light up. The darker the surrounding is, the brighter the RGB LED strip will be.

  • Breathing Sword

Introduction: When the Laser Sword lies flat, the LEDs will repeat lighting up and going out in a rhythmic way, just like “breathing”

  • Auroral Sword

Introduction: The Auroral Sword can be put into service when it is enabled, without any other operation. After it is enabled, the RGB LED strip will present a flow condition, just like the aurora.

  • Light Saber

Introduction: When the Light Saber is enabled, the music sounds and LED color changes several times.

The LEDs will go out one by one when the Laser Saber is put down and will light up when the Laser Sword is raised.

When “sensor 1” and “sensor 2” at the line patrolling module are touched at the same time, LED color changes.

 

Makeblock App control panel for Laser Sword

Makeblock APP has provided a control panel for Laser Sword which allows you to quickly control your Laser sword with a mobile device using the preset consoles. Below are instructions on how to operate the console for Laser Sword.

The left color ring can change the color of Laser Sword strip, while the right color ring can change the color of on-board LEDs.

 

Laser Sword Assembly Instructions

To download the Laser Sword assembly instructions please click here.

 

Frequently Asked Questions

Q1: Why the program runs abnormally when the official mBlock case program or the official console for MakeBlock APP is in use?

A: If the battery runs short of power, under-voltage may cause abnormal running of the program. Please replace the batteries.

 

Q2: Why the laser sword cannot be controlled when connected with Makeblock APP?

A: When the Auriga control board has had a writer, please use mBlock connect → Reset Default Program → mBot Ranger instruction to reset default program, then the console for Makeblock app can be used.