Me USB Host

微信截图_20160129113429

Description

Me USB Host is an adapter for USB devices. You can use it to connect a Makeblock mainboard to a USB device, such as a USB joystick, a mouse, or a thumb drive. So you can control your robot with your own joystick or something else.

Now, we can add new controller method for mBot using wireless joystick: mBot controlled by Wireless Joystick using Me USB Host.

Features

  • Main chip: CH375B
  • Reserved pads for advanced DIY
  • Hot plug NOT supported
  • 16mm interval M4 mounting holes, compatible with Makeblock beams
  • 2.54mm pin holes for connecting with Dupont wire
  • Easy wiring with 6P6C RJ25 interface
  • Arduino library for easy programming

Specification

  • Supported device: HID device whose descriptor is shorter than 64 bytes
  • Rated Voltage: 5V
  • Size: 24 x 48 x 16 mm (length x width x height)

Schematic

Me USB Host

One thought on “Me USB Host”

  1. Set MeUSBHost joypad(PORT_5); The USB host must be attached to port 5 joypad is a device name. The MeUSBHost must be unplugged during the upload of the program.

Comments are closed.